Wheelock MT4-12-LS Anleitung zur Fehlerbehebung PDF herunterladen (Seite 75)

– 75–

N.C.

N.O.

N.C.

N.O.

N.C.

N.O.

2-WIRE SMOKE DETECTOR LOOP

REMOTE KEYPAD.

OPTIONAL FOR

SLAVE DACT

INSTALLATIONS.

REQUIRED FOR

STAND ALONE

CONTROL

INSTALLATIONS.

YELLOW

GREEN

BLACK

RED

10 11

13 14 15

17 18

DATA OUT

DATA IN

GROUND

AUX. POWER +

ZONE 5 –

ZONE 5 +

ZONE 4 +

ZONE 3/ZONE 4 -

ZONE 3 +

ZONE 2 +

ZONE 1/ZONE 2 –

ZONE 1+

5110XM SUMMARY OF CONNECTIONS

THIS EQUIPMENT SHOULD BE INSTALLED IN ACCORDANCE WITH THE NATIONAL FIRE

PROTECTION ASSOCIATION’S STANDARD 72 (NATIONAL FIRE PROTECTION ASSOC.,

BATTERY MARCH PARK, QUINCY, MA 02269). PRINTED INFORMATION DESCRIBING

PROPER INSTALLATION, OPERATION, TESTING, MAINTENANCE, AND REPAIR SERVICE IS

PROVIDED WITH THIS EQUIPMENT.

WARNING:

OWNER’S INSTRUCTION NOTICE NOT TO BE REMOVED

Refer to the 5110XM Installation Instructions N8026

for additional information

MAY BE USED AS A SLAVE DACT PROVIDING CENTRAL OR REMOTE STATION SERVICE FOR A CENTRAL

OR REMOTE STATION UL LISTED FACP. MAY ALSO BE USED AS A STAND-ALONE NON-CODED LOCAL,

CENTRAL STATION AND REMOTE STATION PROTECTED PREMISES UNIT PROVIDING MANUAL FIRE

ALARM, AUTOMATIC FIRE ALARM, SPRINKLER SUPERVISORY AND WATER FLOW ALARM. INSTALLATION

LIMITS UNDER JURISDICTION OF LOCAL AUTHORITY.

ENCLOSED TRANSFORMER

(LOWER LEFT HAND CORNER OF 5110XM CABINET

REPLACE COVER AFTER WIRING

↓

SEE AC

TRANSFORMER

CONNECTIONS

ABOVE

(SUPERVISED)

NOTES:

Note 1:

Supervision may be disabled by cutting jumper W2 and

programming zone 6 for no response.

Note 2:

The combined standby current drawn from aux power

and relay power cannot exceed 350mA.

The combined alarm current drawn from aux power,

relay power and bell cannot exceed 1.0A

Note 3:

All circuits are power limited except transformer 18VAC

output.

CIRCUIT CONTROL UNIT SMOKE DETECTORS

(ZONE) DELAY - SEC MODEL DELAY - SEC

ZONE 1-5 NOTES:

• ALL ZONES PROVIDE STYLE B SUPERVISION

• ZONE RESISTANCE (EXCLUDING EOLR)

+ ZONES 1-4: 300 OHM MAX

+ ZONE 5: 100 OHMS MAX

• ZONE RESPONSE: 300-500 MILLISECOND

(ALL ZONES)

• ZONE 5 RATINGS: + 10-14VDC

+ 2 MA MAX FOR 2-WIRE SMOKE

DETECTORS. UP TO 16 DETECTORS OF TYPE

SPECIFIED IN INSTRUCTIONS MAY BE USED.

+ UL COMPATIBILITY ID: A

• 2K EOLR IS ADEMCO MODEL 610-7

ALARM DEVICE MANUFACTURING CO.

A DIVISION OF PITTWAY CORPORATION

165 Eileen Way, Syosset, New York, 11791

RJ31X

BACK-UP DIALER

PHONE JACK

COMPLIES WITH FCC RULES, PART 68

FCC REG. NO: AC398U-68192-AL-E

RINGER EQUIVALENCE: 0.7B

THE DELAY TIME MARKED ON THE INSTALLED

DETECTORS IS TO BE USED

BELL CIRCUIT SUPERVISION JUMPER

INTACT: SUPERVISED USING 2K EOLR

CUT: NOT SUPERVISED (NO EOLR USED)

(WHITE)

AUXILIARY

RELAY

SMOKE

BELL+

BELL-

(RED)

RELAY POWER

JUMPER

EARTH

GROUND

MAIN DIALER

PHONE JACK

BUZZER SILENCE SWITCH

PUSH ONCE TO SILENCE,

PUSH AGAIN TO RESET

LED INDICATOR BOARD

PLUG BOARD

INTO THE J5 9 PIN

HEADER AS SHOWN

AC POWER

(GREEN)

BATT TROUBLE

(YELLOW)

COMM FAIL

(YELLOW)

LINE FAULT

(YELLOW)

SILENCED

(YELLOW)

WARNING BUZZER

ACTIVATES ON ALARMS,

SUPERVISORIES AND TROUBLES

– AUX POWER RATING: 10-14VDC,

350mA MAX, POWER LIMITED

NOT SUPERVISED UL

(SEE NOTE 2)

– 6137, 6137R, 6139 OR 6139R MAY

BE USED AS A REMOTE KEYPAD,

KEYPAD COLOR SUBJECT TO

APPROVAL OF LOCAL AUTHORITY.

ONLY 6139 OR 6139R MAY BE USED

TO PROGRAM PANEL

– REFER TO INSTRUCTIONS FOR

MAX # OF KEYPADS AND WIRE

LENGTH RESTRICTIONS.

KEYPAD CONNECTION NOT

SUPERVISED

}

MAKE CONNECTIONS TO SEPARATE TELEPHONE

LINES USING CABLES SUPPLIED. SUPERVISION

IS PROGRAMMABLE

WARNING: TO PREVENT RISK OF ELECTRICAL

SHOCK, DISCONNECT TELCO JACK

BEFORE SERVICING THIS PANEL

CONNECTION OF THE FIRE ALARM SIGNAL TO A

FIRE ALARM HEADQUARTERS OR A CENTRAL

STATION SHALL BE PERMITTED ONLY WITH

THE APPROVAL OF THE LOCAL AUTHORITY

HAVING JURISDICTION.

N8027 4/96

MODEL

#610-7

– AUX RELAY HAS PROGRAMMABLE FUNCTION

(NOT SUPERVISED)

– JUMPER W3 INTACT: 10-14VDC ON TERMINAL 6

350mA MAX (STANDBY)/1A MAX (ALARM),

POWER LIMITED (SEE NOTE 2). USE TERMINAL 18

FOR GROUND RETURN.

– JUMPER W3 CUT: NO VOLTAGE ON TERMINAL 6.

RELAY CONTACT RATING: 30VAC/VDC,

2A MAX, RESISTIVE LOADS

– PROVIDES STYLE Y SUPERVISION

WHEN POLARIZED ALARM

DEVICES ARE USED (SEE NOTE 1)

– RATINGS:

10-14VDC,

1A MAX,

POWER LIMITED

(SEE NOTE 2)

BLUE

N.O.

POLE/RELAY +

N.C.

GREEN

SEE

EARTH GROUND

CONNECTIONS

ABOVE

BATT –

BATT +

RED

BLACK

USE BATTERY CABLES

SUPPLIED

12V LEAD ACID BATTERY

7AH MIN/14 AH MAX.

SEE INSTRUCTIONS FOR

REQUIRED CAPACITY AND

BATTERY MOUNTING

FLOAT CHARGING

VOLTAGE: 13.7V

MAXIMUM CHARGING

CURRENT: 1.0A

BATTERY NORMALLY NEED

NOT BE REPLACED FOR AT

LEAST 3 YEARS

}

18VAC, 40VA NOT

POWER LIMITED.

CONNECT TO

AC POWER

TERMINALS 1, 2

MAINTAIN 1/4”

SPACING TO OTHER

WIRING.

120 VAC, 60Hz,

600mA MAX

CONNECT TO

A DEDICATED

CIRCUIT

NOTE: USE WIRES HAVING INSTALLATION

RATED FOR 90°C OR HIGHER

≈

GREEN

BLACK

BLUE

WHITE

2A CIRCUIT

BREAKER

}

ALARM POLARITY SHOWN

BELL

HORN

CONNECT TO EARTH

GROUND TERMINAL 8

WARNING:

THIS UNIT MAY BE PROGRAMMED TO INCLUDE AN ALARM

VERIFICATION FEATURE THAT WILL RESULT IN A DELAY

OF THE SYSTEM ALARM SIGNAL FROM THE INDICATED

FIRE CIRCUITS. THE TOTAL DELAY (CONTROL UNIT PLUS

SMOKE DETECTORS) SHALL NOT EXCEED 60 SECONDS.

NO OTHER DEVICES SHALL BE CONNECTED TO THESE

CIRCUITS UNLESS APPROVED BY THE LOCAL AUTHORITY

HAVING JURISDICTION.

CONNECT TO

PROPER EARTH

GROUND. SEE

INSTRUCTIONS

BACK-UP

DIALER

LINE

SEIZE

(GREEN)

MAIN

DIALER

LINE

SEIZE

(GREEN)

CONTROL

Ademco 5110XM SUMMARY OF CONNECTIONS

1 2 ... 70 71 72 73 74 75 76

Kommentare zu diesen Handbüchern

Keine Kommentare

Wheelock MT4-12-LS Anleitung zur Fehlerbehebung Seite 75

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Rauchmelder Wheelock MT4-12-LS