Wheelock MT-24-LSM Bedienerhandbuch PDF herunterladen (Seite 2)

FREQUENTLY ASKED TECHNICAL QUESTIONS

NUMBER

QUESTION ANSWER

11 "How do I hook up the NS4 separating the horn

and strobe while using the DSM Module and have

the horns do a Code 3 Pattern?"

Connect a NAC Circuit from the FACP to the Audible

Terminals of the DSM. Jumper from the Audible Terminals

to Input 1. Connect the Strobe portion of the NS4 to output

1 of the DSM. Connect the Horn portion of the NS4 to a

separate NAC Circuit from the FACP. Have the FACP

provide the Code 3 Pattern.

12 "How do I set either the NS or the AS appliances

for continuous horn operation?"

Remove the factory installed jumper from the Code 3

position. Note that you cannot get continuous horn when

connected to a sync module.

13 "I have the CH 70 Chime Strobe and I want to use

it with a Sync /module."

Wire the strobe portion of the Chime Strobe through the

Sync Module. Wire the Chime portion through your FACP

on a separate NAC Circuit and set the Chime to single

stroke and pulse the NAC Circuit.

14 "How do I set the DIP switches for Code 3 on a

MT-12/24-R?"

Look at the SW1 switch. Set positions 2 & 3 to the up

position and position 4 to the down position.

15 "How do I set the priorities on the AMT

appliance?"

By setting the SW 1 DIP switch. Position 1 sets the dB

level from either high or low. Positions 2 through 4 sets the

priorities of the signal.

16 "What kind of Back Box do I need to mount a bell

outdoors?"

The correct box to use is a WBB-R.

17 "What kind of Back Box do I need for the Series

E70 & ET70 Speakers when I need to mount the

liance on the surface?"

The correct box to use is the SBB-R for Red or the

SBB-W for White.

18 "How do I increase the output of the

STH-15S-R?"

Remove the cover plate on the side of the horn and adjust

the tap setting using a flat head screwdriver.

19 "On the new Mini Horn (MIZ-24TC-R), how do I set

the appliance for Code 3?"

There is a jumper plug on the rear of the appliance. Set the

plug so the plug is on the left pin.

1 2 3 4 5 6 7 ... 11 12

QUESTION ANSWER 1

Kommentare zu diesen Handbüchern

Keine Kommentare

Wheelock MT-24-LSM Bedienerhandbuch Seite 2

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Rauchmelder Wheelock MT-24-LSM